197
Chapter 25 PoE Commands
Note: Only T1600G-28PS and T1600G-52PS support PoE function.
PoE (Power over Ethernet) technology describes a system to transmit electrical power along
with data to remote devices over standard twisted-pair cable in an Ethernet network. It is
especially useful for supplying power to IP telephones, wireless LAN access points, cameras
and so on.
A time-range based PoE enables you to implement PoE power supply by differentiating the
time-ranges.
25.1 power inline consumption (global)
Description
The power inline consumption command is used to configure the max
power the PoE switch can supply globally.
Syntax
power inline consumption
power-limit
Parameter
power-limit
——The max power the PoE switch can supply. For T1600G-28PS
it ranges from 1 to 192W, and for T1600G-52PS it ranges from 1 to 384W.
Command Mode
Global Configuration Mode
Example
Configure the max power the PoE switch can supply as 160W:
T1600G-52PS(config)# power inline consumption 160
25.2 power profile
Description
The power profile command is used to create a PoE profile for the switch. To
delete the configured PoE profile configuration, please use no power profile
command. PoE Profile is a short cut for the configuration of the PoE port. In a
PoE profile, the PoE status, PoE priority and power limit are configured. You
can specify a PoE profile for each PoE port individually.
To Next Page
Loading...
