TP-Link T1600G-52PS Cli Reference Guide

319
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the information of VLAN 2:
T1600G-52TS(config)#show interface vlan 2
32.12 show ip interface
Description
This show ip interface command is used to display the detailed information
of the specified Layer 3 interface.
Syntax
show ip interface [ gigabitEthernet port | port-channel port-channel-id |
loopback id | vlan vlan-id ]
Parameter
port —— The port number.
port-channel-id —— The ID of the port channel. Member ports in this port
channel should all be routed ports.
id —— The loopback interface ID.
vlan-id —— The VLAN interface ID.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the detailed information of the VLAN interface 2:
T1600G-52TS(config)# show ip interface vlan 2

TP-Link T1600G-52PS Specifications

General

PoE Ports	48
Switching Capacity	104 Gbps
Forwarding Rate	77.4Mpps
PoE Budget	384 W
Power Supply	AC 100-240V, 50/60Hz
Mounting	Rack Mountable
MAC Address Table	16K
Jumbo Frame	9KB
Packet Buffer Memory	4 MB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 90% non-condensing
Layer	Layer 2+
Dimensions (W x D x H)	440 x 44 x 44 mm
Standards and Protocols	IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x, IEEE 802.3af, IEEE 802.3at
Quality of Service	8 queues per port
VLAN	4K VLANs
Management	Web-based, SNMP
Security	802.1X
Ports	48 x 10/100/1000 Mbps RJ45 ports, 4 x 1G SFP slots