45
7.4 lacp port-priority
Description
The lacp port-priority command is used to configure the LACP port priority
for specified ports. To return to the default configurations, please use no lacp
port-priority command.
Syntax
lacp port-priority
pri
no lacp port-priority
Parameter
pri
—— The port priority, ranging from 0 to 65535. It is 32768 by default.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the LACP port priority as 1024 for ports 1-3:
T1600G-52TS(config)# interface range gigabitEthernet 1/0/1-3
T1600G-52TS(config-if-range)# lacp port-priority 1024
Configure the LACP port priority as 2048 for port 4:
T1600G-52TS(config)# interface gigabitEthernet 1/0/4
T1600G-52TS(config-if)# lacp port-priority 2048
7.5 show etherchannel
Description
The show etherchannel command is used to display the EtherChannel
information.
To Next Page
Loading...
