TP-Link T1600G-52PS Cli Reference Guide

54
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Configure that only the users connected to ports 2-6 are allowed to access the
switch:
T1600G-52TS(config)# user access-control port-based interface
gigabitEthernet 1/0/2-6
8.6 telnet
Description
The telnet enable command is used to enable the Telnet function. To disable
the Telnet function, please use the telnet disable command. This function is
enabled by default.
Syntax
telnet enable
telnet disable
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Disable the Telnet function:
T1600G-52TS(config)# telnet disable
8.7 show user account-list
Description
The show user account-list command is used to display the information of
the current users.
Syntax
show user account-list

TP-Link T1600G-52PS Specifications

General

PoE Ports	48
Switching Capacity	104 Gbps
Forwarding Rate	77.4Mpps
PoE Budget	384 W
Power Supply	AC 100-240V, 50/60Hz
Mounting	Rack Mountable
MAC Address Table	16K
Jumbo Frame	9KB
Packet Buffer Memory	4 MB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 90% non-condensing
Layer	Layer 2+
Dimensions (W x D x H)	440 x 44 x 44 mm
Standards and Protocols	IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x, IEEE 802.3af, IEEE 802.3at
Quality of Service	8 queues per port
VLAN	4K VLANs
Management	Web-based, SNMP
Security	802.1X
Ports	48 x 10/100/1000 Mbps RJ45 ports, 4 x 1G SFP slots