TP-Link T1600G-52PS - Ipv6 Mld Snooping Last-Listener Query-Inteval; Ipv6 Mld Snooping Last-Listener Query-Count

257
28.8 ipv6 mld snooping last-listener query-inteval
Description
The ipv6 mld snooping last-listener query-inteval command is used to
specify the interval to send Specific Query Message. The default value is 1
second. To restore the default interval, please use no ipv6 mld snooping
last-listener query-inteval command.
Syntax
ipv6 mld snooping last-listener query-inteval interval
no ipv6 mld snooping last-listener query-inteval
Parameter
interval —— Specify the interval to send Specific Query Message in seconds,
ranging from 1 to 5.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Specify the interval of Specific Query Message to 3 seconds:
T1600G-52TS(config)# ipv6 mld snooping last-listener query-inteval 3
28.9 ipv6 mld snooping last-listener query-count
Description
The ipv6 mld snooping last-listener query-count command is used to
specify the numbers of Specific Query Message to be sent. The default value
is 2. To restore the default number, please use no ipv6 mld snooping
last-listener query-count command.
Syntax
ipv6 mld snooping last-listener query-count num
no ipv6 mld snooping last-listener query-count
Parameter
num —— Specify the numbers of Specific Query Message to be sent, ranging
from 1 to 5.
Command Mode
Global Configuration Mode