44
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the Aggregate Arithmetic for LAG as “src-dst-ip”:
T1600G-52TS(config)# port-channel load-balance src-dst-ip
7.3 lacp system-priority
Description
The lacp system-priority command is used to configure the LACP system
priority globally. To return to the default configurations, please use no lacp
system-priority command.
Syntax
lacp system-priority
pri
no lacp system-priority
Parameter
pri
—— The system priority, ranging from 0 to 65535. It is 32768 by default.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the LACP system priority as 1024 globally:
T1600G-52TS(config)# lacp system-priority 1024
To Next Page
Loading...
