TP-Link T1600G-52PS - Dot1 X Port-Control

108
Syntax
dot1x guest-vlan
no dot1x guest-vlan
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the Guest VLAN function for Gigabit Ethernet port 1/0/2:
T1600G-52TS(config)#interface gigabitEthernet 1/0/2
T1600G-52TS(config-if)#dot1x guest-vlan
15.11 dot1x port-control
Description
The dot1x port-control command is used to configure the Control Mode of
IEEE 802.1X for the specified port. By default, the control mode is “auto”. To
restore to the default configuration, please use no dot1x port-control
command.
Syntax
dot1x port-control {auto | authorized-force | unauthorized-force}
no dot1x port-control
Parameter
auto | authorized-force | unauthorized-force —— The Control Mode for the
port.
auto:
In this mode, the port will normally work only after passing the 802.1X
Authentication.
authorized-force: In this mode, the port can work normally without passing
the 802.1X Authentication.