TP-Link T1600G-52PS Cli Reference Guide

128
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Configure the daylight saving time as USA standard:
T1600G-52TS(config)#system-time dst predefined USA
17.4 system-time dst date
Description
The system-time dst date command is used to configure the one-off
daylight saving time. The start date is in the current year by default. The time
range of the daylight saving time must shorter than one year, but you can
configure it spanning years. To disable DST function, please use no
system-time dst command.
Syntax
system-time dst date { smonth } { sday } { stime } { syear } { emonth } { eday } { etime }
{
eyear }[ offset ]
no system-time dst
Parameter
smonth ——The start month of the daylight saving time. There are 12 values
showing as follows: Jan, Feb, Mar, Apr, May, Jun, Jul, Aug, Sep, Oct, Nov, Dec.
sday —— The start day of the daylight saving time, ranging from 1 to 31. Here
you should show special attention to February and the differences between a
solar month and a lunar month.
stime —— The start moment of the daylight saving time, HH:MM.
syear —— The start year of the daylight saving time.
emonth —— The end month of the daylight saving time. There are 12 values
showing as follows: Jan, Feb, Mar, Apr, May, Jun, Jul, Aug, Sep, Oct, Nov, Dec.
eday —— The end day of the daylight saving time, ranging from q to 31. Here
you should show special attention to February and the differences between a
solar month and a lunar month.
etime —— The end moment of the daylight saving time, HH:MM.
eyear —— The end year of the daylight saving time.
offset —— The number of minutes to add during the daylight saving time. It is
60 minutes by default.

TP-Link T1600G-52PS Specifications

General

Brand	TP-Link
Model	T1600G-52PS
Category	Switch
Language	English