115
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the global MAC address notification and table full notification, specify
the notification sending interval as 2 seconds:
T1600G-52TS(config)# mac address-table notification global-status
enable table-full-status enable interval 2
16.5 mac address-table notification (interface)
Description
The mac address-table notification command is used to configure the
MAC change notification on port.
Syntax
mac address-table notification { [ learn-mode-change enable | disable ]
[ exceed-max-learned enable | disable ] [ new-mac-learned enable |
disable ] }
Parameter
learn-mode-change enable | disable —— Enable/Disable the
learn-mode-change notification. With this feature enabled, a SNMP
notification is generated and sent to the network management system (NMS)
when the learning mode of this port changes. To configure the learning mode
configuration, please refer to mac address-table max-mac-count
.
exceed-max-learned enable | disable —— Enable/Disable the MAC address
threshold notification on this port. With this feature enabled, a SNMP
notification is generated and sent to the network management system (NMS)
when the MAC address threshold limit on this port is reached or exceeded.
To configure the port’s MAC address threshold, please refer to
mac
address-table max-mac-count.
new-mac-learned enable | disable —— Enable/Disable the
new-mac-learned notification on this port. With this feature enabled, a SNMP
notification is generated and sent to the network management system (NMS)
when the port learns a new MAC address.
To Next Page
Loading...
