TP-Link T1600G-52PS - Show Monitor Session

177
2. Monitored ports number is not limited, but it can’t be the monitoring port
at the same time.
3. Whether the monitoring port and monitored ports are in the same VLAN
or not is not demanded strictly.
4. The monitoring port cannot be link-aggregation member.
Example
Create monitor session 1, then configure port 4, 5, 7 as monitored port and
enable ingress monitoring:
T1600G-52TS(config)# monitor session 1 source interface
gigabitEthernet 1/0/4-5,1/0/7 rx
Delete port 4 in monitor session 1 and its configuration:
T1600G-52TS(config)# no monitor session 1 source interface
gigabitEthernet 1/0/4 rx
21.3 show monitor session
Description
The show monitor session command is used to display the configuration of
port monitoring.
Syntax
show monitor session [ session_num ]
Parameter
session_num —— The monitor session number, can only be specified as 1. It
is optional.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the monitoring configuration of monitor session 1:
T1600G-52TS(config)# show monitor session 1