181
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Specify the interval-time as 50 seconds:
T1600G-52TS(config)# loopback-detection interval 50
23.3 loopback-detection recovery-time
Description
The loopback-detection recovery-time command is used to configure the
time after which the blocked port would automatically recover to normal
status.
Syntax
loopback-detection recovery-time
recovery-time
Parameter
recovery-time
—— The time after which the blocked port would automatically
recover to normal status, and the loopback detection would restart. It is
integral times of detection interval, ranging from 1 to 100 and the default
value is 3.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the recovery-time
as 3 times of detection interval:
T1600G-52TS(config)# loopback-detection recovery-time 3
To Next Page
Loading...
Need help?
General