87
Chapter 13 System Log Commands
The log information will record the settings and operation of the switch respectively for you to
monitor operation status and diagnose malfunction.
13.1 logging buffer
Description
The logging buffer command is used to store the system log messages to an
internal buffer. To disable the log buffer function, please use the no logging
buffer command. Local Log is the system log information saved in the switch.
It has two output channels, that is, it can be saved to two different positions,
log buffer and log flash memory. The log buffer indicates the RAM for saving
system log and the information in the log buffer can be got by
show logging
buffer command. It will be lost when the switch is restarted.
Syntax
logging buffer
no logging buffer
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Enable the system log buffer:
T1600G-52TS(config)#logging buffer
13.2 logging buffer level
Description
The logging buffer level command is used to configure the severity level and
the status of the configuration input to the log buffer. To return to the default
configuration, please use no logging buffer level command.
To Next Page
Loading...
Need help?
General