TP-Link T1600G-52PS Cli Reference Guide

176
T1600G-52TS(config)# no monitor session 1 destination interface
gigabitEthernet 1/0/2
Delete the monitor session 1:
T1600G-52TS(config)# no monitor session 1
21.2 monitor session source interface
Description
The monitor session source interface command is used to configure the
monitored port/ LAG. To delete the corresponding monitored port, please
use no monitor session source
interface command.
Syntax
monitor session session_num source interface { gigabitEthernet port-list |
port-channel lagid-list } mode
no monitor session session_num source interface { gigabitEthernet
port-list |
port-channel lagid-list } mode
Parameter
session_num —— The monitor session number, can only be specified as 1.
port-list —— The list of monitored port. It is multi-optional.
lagid-list ——The list of monitored LAG.
mode —— The monitor mode. There are three options: rx, tx and both. Rx
(ingress monitoring mode), means the incoming packets received by the
monitored port will be copied to the monitoring port. Tx (egress monitoring
mode), indicates the outgoing packets sent by the monitored port will be
copied to the monitoring port. Both (ingress and egress monitoring), presents
the incoming packets received and the outgoing packets sent by the
monitored port will both be copied to the monitoring port.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
User Guidelines
1. The monitoring port is corresponding to current interface configuration
mode.

TP-Link T1600G-52PS Specifications

General

Brand	TP-Link
Model	T1600G-52PS
Category	Switch
Language	English