TP-Link T1600G-52PS - Loopback-Detection Recover

183
Manual: Block status can only be removed manually.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the loopback detection process-mode as port-based and
recovery-mode as manual for port 2:
T1600G-52TS(config)# interface gigabitEthernet 1/0/2
T1600G-52TS(config-if)# loopback-detection config process-mode
port-based recovery-mode manual
23.6 loopback-detection recover
Description
The loopback-detection recover command is used to remove the block
status of selected ports, recovering the blocked ports to normal status,
Syntax
loopback-detection recover
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Recover the blocked port 2 to normal status:
T1600G-52TS(config)# interface gigabitEthernet 1/0/2
T1600G-52TS(config-if)# loopback-detection recover