TP-Link T1600G-52PS Cli Reference Guide

258
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Specify the number of Specific Query Message to 3:
T1600G-52TS(config)# ipv6 mld snooping last-listener query-count 3
28.10 ipv6 mld snooping vlan-config
Description
The ipv6 mld snooping vlan-config command is used to enable VLAN MLD
Snooping function or to modify MLD Snooping parameters, and to create
static multicast IP entry. To disable the VLAN MLD Snooping function, please
use no ipv6 mld snooping vlan-config command.
Syntax
ipv6 mld snooping vlan-config vlan-id-list [ rtime router-time | mtime
member-time | rport interface { gigabitEthernet port-list | port-channel
lagid } ]
ipv6 mld snooping vlan-config
vlan-id-list static ip interface
{ gigabitEthernet
port-list | port-channel lagid }
no ipv6 mld snooping vlan-config
vlan-id-list [ rtime router-time | mtime
member-time | rport interface { gigabitEthernet port-list | port-channel
lagid } ]
no ipv6 mld snooping vlan-config
vlan-id-list static ip interface
{ gigabitEthernet
port-list | port-channel lagid }
Parameter
vlan-id-list —— The ID list of the VLAN desired to modify configuration,
ranging from 1 to 4094, in the format of 1-3, 5.
router-time
—— Router Port Time. Within this time, if the switch does not
receive MLD query message from the router port, it will consider this port is
not a router port any more. Router Port Time ranges from 60 to 600 in
seconds. By default, it is 0 and the global router-time will be used.
member-time —— Member Port Time. Within this time, if the switch does not
receive MLD report message from the member port, it will consider this port
is not a member port any more. Member Port Time ranges from 60 to 600 in
seconds. By default, it is 0 and the global member-time will be used.

TP-Link T1600G-52PS Specifications

General

Brand	TP-Link
Model	T1600G-52PS
Category	Switch
Language	English