TP-Link T1600G-52PS Cli Reference Guide

204
25.10 power inline supply
Description
The power inline supply command is used to configure the PoE status of the
corresponding port.
Syntax
power inline supply { enable | disable }
Parameter
enable | disable —— The PoE status of the port. By default, the PoE status is
“enable”.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable the PoE feature for port 2:
T1600G-52PS(config)# interface gigabitEthernet 1/0/2
T1600G-52PS(config-if)# power inline supply enable
25.11 power inline profile
Description
The power inline profile command is used to bind a PoE profile to the
corresponding port. To cancel the bind relation, please use no power inline
profile command.
Syntax
power inline profile name
no power inline profile
Parameter
name —— The name of the PoE profile to be bound to the port. If the name
being assigned contains spaces then put it inside double quotes.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)

TP-Link T1600G-52PS Specifications

General

PoE Ports	48
Switching Capacity	104 Gbps
Forwarding Rate	77.4Mpps
PoE Budget	384 W
Power Supply	AC 100-240V, 50/60Hz
Mounting	Rack Mountable
MAC Address Table	16K
Jumbo Frame	9KB
Packet Buffer Memory	4 MB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 90% non-condensing
Layer	Layer 2+
Dimensions (W x D x H)	440 x 44 x 44 mm
Standards and Protocols	IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x, IEEE 802.3af, IEEE 802.3at
Quality of Service	8 queues per port
VLAN	4K VLANs
Management	Web-based, SNMP
Security	802.1X
Ports	48 x 10/100/1000 Mbps RJ45 ports, 4 x 1G SFP slots