TP-Link T1600G-52PS - Lldp Tlv-Select

301
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the SNMP notification for Gigabit Ethernet port 1/0/1:
T1600G-52TS(config)#interface gigabitEthernet 1/0/1
T1600G-52TS(config-if)#lldp snmp-trap
30.7 lldp tlv-select
Description
The lldp tlv-select command is used to configure TLVs to be included in
outgoing LLDPDU. To exclude TLVs, please use no lldp tlv-select command.
By default, All TLVs are included in outgoing LLDPDU.
Syntax
lldp tlv-select { [ port-description ] [ system-capability ] [ system-description ]
[ system-name ] [ management-address ] [ port-vlan ] [ protocol-vlan ]
[ vlan-name ] [ link-aggregation ] [ mac-phy-cfg ] [ max-frame-size ] [ power ]
[ all ] }
no lldp tlv-select { [ port-description ] [ system-capability ]
[ system-description ] [ system-name ] [ management-address ] [ port-vlan ]
[ protocol-vlan ] [ vlan-name ] [ link-aggregation ] [ mac-phy-cfg ]
[ max-frame-size ] [ power ] [ all ] }
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Exclude “management-address” and “port-vlan-id” TLVs in LLDPDU outgoing
from Gigabit Ethernet port 1/0/1:
T1600G-52TS(config)# interface gigabitEthernet 1/0/1
T1600G-52TS(config-if)# no lldp tlv-select management-address port-vlan