302
30.8 lldp med-fast-count
Description
The lldp med-fast-count command is used to configure the number of the
LLDP-MED frames that will be sent out. When LLDP-MED fast start
mechanism is activated, multiple LLDP-MED frames will be transmitted based
on this parameter. The default value is 4. To return to the default
configuration, please use no lldp med-fast-count command.
Syntax
lldp med-fast-count
count
no lldp med-fast-count
Parameter
count
—— Configure the Fast Start Count parameter. It ranges from 1 to 10.
By default, it is 4.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Specify Fast Start Count as 5:
T1600G-52TS(config)# lldp med-fast-count 5
30.9 lldp med-status
Description
The lldp med-status command is used to enable the LLDP-MED feature for
the corresponding port. After the LLDP-MED feature is enabled, the port's
Admin Status will be changed to Tx&Rx. To disable the LLDP-MED feature for
the corresponding port, please use no lldp med-status command.
Syntax
lldp med-status
no lldp med-status
To Next Page
Loading...
Need help?
General