90
13.5 logging file flash level
Description
The logging file flash level command is used to specify the system log
message severity level. Messages with a severity level equal to or higher than
this value will be stored to the flash. To restore to the default level, please use
no logging file flash level command.
Syntax
logging file flash level
level
no logging file flash level
Parameter
level
—— Severity level of the log message. There are 8 severity levels
marked with values 0-7. The smaller value has the higher priority. Only the log
with the same or smaller severity level value will be saved to the flash. By
default, it is 3 indicating that the log message marked with 0~3 will be saved
in the log flash.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Save the log messages with their severities equal or higher than 7 to the
flash :
T1600G-52TS(config)#logging file flash level 7
13.6 logging host index
Description
The logging host index command is used to configure the Log Host. To clear
the configuration of the specified Log Host, please use no logging host
index command. Log Host is to receive the system log from other devices.
You can remotely monitor the settings and operation status of other devices
through the log host.
To Next Page
Loading...
Need help?
General