246
Parameter
start-ip
—— The start filtering multicast IP address.
end-ip
—— The end filtering multicast IP address.
Command Mode
Profile Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure one of the filter multicast address entry as range 225.1.1.1 to
226.3.2.1 in profile 1:
T1600G-52TS(config)# ip igmp profile 1
T1600G-52TS(config-igmp-profile)#range 225.1.1.1 226.3.2.1
27.24 ip igmp filter
Description
The ip igmp filter command is used to bind the specified profile to the
interface. To delete the binding, please use no ip igmp filter command.
Syntax
ip igmp filter
profile-id
no ip igmp filter
Parameter
profile-id
—— Specify the profile ID, ranging from 1 to 999.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface port-channel / interface range port-channel)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Bind profile 1 to interface gigabitEthernet 1/0/2:
T1600G-52TS(config)# interface gigabitEthernet 1/0/2
To Next Page
Loading...
Need help?
General