TP-Link T1600G-52PS Cli Reference Guide

342
34.21 ip http login authentication
Description
The ip http login authentication command is used to apply the login
authentication method list to users accessing through HTTP. To restore to
the default authentication method list, please use the no ip http login
authentication command.
Syntax
ip http login authentication { method-list }
no ip http login authentication
Parameter
method-list —— Specify the login method list on the HTTP access. It is
“default” by default, which contains the method “local”.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Configure the login authentication method list on the HTTP access as “list1”:
T1600G-52TS(config)# ip http login authentication list1
34.22 ip http enable authentication
Description
The ip http enable authentication command is used to apply the privilege
authentication method list to users accessing through HTTP. To restore to
the default authentication method list, please use the no ip http enable
authentication command.
Syntax
ip http enable authentication { method-list }
no ip http enable authentication

TP-Link T1600G-52PS Specifications

General

PoE Ports	48
Switching Capacity	104 Gbps
Forwarding Rate	77.4Mpps
PoE Budget	384 W
Power Supply	AC 100-240V, 50/60Hz
Mounting	Rack Mountable
MAC Address Table	16K
Jumbo Frame	9KB
Packet Buffer Memory	4 MB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 90% non-condensing
Layer	Layer 2+
Dimensions (W x D x H)	440 x 44 x 44 mm
Standards and Protocols	IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x, IEEE 802.3af, IEEE 802.3at
Quality of Service	8 queues per port
VLAN	4K VLANs
Management	Web-based, SNMP
Security	802.1X
Ports	48 x 10/100/1000 Mbps RJ45 ports, 4 x 1G SFP slots