314
32.4 interface range port-channel
Description
This interface range port-channel command is used to create multiple
port-channel interfaces.
Syntax
interface range port-channel
port-channel-list
Parameter
port-channel-list
—— The list of the port-channel interface, ranging from 1 to
14, in the format of 1-3, 5.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Create the port-channel interfaces 1,3,4 and 5:
T1600G-52TS(config)# interface port-channel 1,3-5
32.5 description
Description
This description command is used to add a description to the Layer 3
interface, including routed port, port-channel interface, loopback interface
and VLAN interface. To clear the description of the corresponding interface,
please use the no description command.
Syntax
description
string
no description
Parameter
string
—— Content of an interface description, ranging from 1 to 32
characters.
To Next Page
Loading...
Need help?
General