TP-Link T1600G-52PS - Dot1 X; Dot1 X Guest-Vlan(Interface)

107
Example
Configure the maximum transfer times of the repeated authentication
request as 5:
T1600G-52TS(config)#dot1x max-reauth-req 5
15.9 dot1x
Description
The dot1x command is used to enable the IEEE 802.1X function for a
specified port. To disable the IEEE 802.1X function for a specified port, please
use no dot1x command.
Syntax
dot1x
no dot1x
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Enable the IEEE 802.1X function for the Gigabit Ethernet port 1/0/1:
T1600G-52TS(config)#interface gigabitEthernet 1/0/1
T1600G-52TS(config-if)#dot1x
15.10 dot1x guest-vlan(interface)
Description
The dot1x guest-vlan command is used to enable the guest VLAN function
for a specified port. To disable the Guest VLAN function for a specified port,
please use no dot1x guest-vlan command. Please ensure that the Control
Type of the corresponding port is port-based before enabling the guest
VLAN function for it.