Xerox Phaser 6280 - Configuration, Memory, and Firmware Errors; Download Error

3-94 Phaser 6280 Color Laser Printer Service Manual
Error Messages and Codes
Configuration, Memory, and Firmware Errors
Download Error
An error occurred because an invalid firmware was installed.
Applicable Chain Link
■ Chain Link 016-500: Erase Flash Error (Download Delete Error)
■ Chain Link 016-501: Write Flash Error (Download Write Error)
■ Chain Link 016-502: Verify Flash Error (Download Verify Error)
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Image Process Board, PL9.1.27
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1. Check the Image Processor Board
for correct installation.
2.Is the Image Processor Board
correctly installed?
Go to step 2. Reseat the
Image
Processor
Board
(
page 8-87).
Go to step 2.
2 1. Does the error still occur? Replace the
Image
Processor Board
(
page 8-87).
Complete.