Xerox Phaser 6280 - Tray 2 Size Switch Assembly (PL7.1.18)

Phaser 6280 Color Laser Printer Service Manual 8-69
Service Parts Disassembly
Tray 2 Size Switch Assembly (PL7.1.18)
1. Remove the Rear Cover (page 8-12).
2. Remove the Right Side Cover (page 8-13).
3. Release the Clamp (PL7.1.15) securing the Size Switch Assembly and
remove the wiring harness.
4. Disconnect the Size Switch wiring harness connector P/J291.
5. Remove 1 screw (10 mm) securing the Size Switch Assembly.
6. Release the one notch on top the Size Switch Assembly and one notch
located on the bottom from the holes of the printer and remove the Size
Switch Assembly.
7. Remove the Clamp from the Size Switch Assembly.
Replacement Note
Replacement Note
Be sure the notch on the bottom of the Size Switch Assembly fits into
the groove on the printer frame.
s6280-224
P/J291