8-58 Phaser 6280 Color Laser Printer Service Manual
Service Parts Disassembly
BIAS Assembly (PL5.1.13)
1. Remove the Rear Cover (page 8-12).
2. Remove the Right Side Cover (page 8-13).
3. Remove the Left Side Cover (page 8-14).
4. Remove the Top Cover (page 8-15).
5. Remove the LED Assembly (page 8-60).
It is not necessary to disconnect the connector on the MCU Board for the
following step.
6. Remove the HVPS (page 8-61).
Keep the relay connector on the printer harness side.
7. Disconnect the Dispenser Assembly (PL5.1.12) wiring harness
connectors and release the wiring harnesses from the Motor Harness
Duct.
8. Release the 2 hooks securing the Motor Harness Duct.
9. Slightly shift the Motor Harness Duct upward to release the convex
section from the printer. Place the connectors through the hole of the
Motor Harness Duct and remove the Motor Harness Duct.
To Next Page
Loading...
