8-76 Phaser 6280 Color Laser Printer Service Manual
Service Parts Disassembly
K Drive Assembly (PL8.1.10)
1. Remove the Rear Cover (page 8-12).
2. Remove the Right Side Cover (page 8-13).
3. Remove the Left Side Cover (page 8-14).
4. Remove the I/P Board Shield (page 8-96).
5. Remove the MCU Board Shield (page 8-94).
6. Disconnect wiring harness connector P/J20 on the MCU Board
(PL9.1.20).
7. Release the K Mode Sensor wiring harness from the 5 clamps and route
the wiring harness through the hole to remove it.
To Next Page
Loading...
