Xerox Phaser 6280 - Out of Memory

Phaser 6280 Color Laser Printer Service Manual 3-97
Error Messages and Codes
Out of Memory
The printer memory is full and cannot continue to print. Print job requires
additional memory.
Applicable Chain Link
■ Chain Link 016-718: Memory Overflow
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Image Processor Board, PL9.1.27
■ Memory Card (Option), PL9.1.30
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1. Check the required memory for the
print job.
2.Print a small size file (example as a
Windows test print).
3.Does the error still occur?
Go to step 2. Add memory
card or separate
the print job.
2 1. Reseat the memory card
(page 8-91).
2.Does the error still occur?
Go to step 3. Complete.
3 1. Check the memory card capacity.
Print the printer Configuration Page:
Menu > Information Pgs >
Configuration.
2.Does the memory meet the print job
requirements?
Go to step 4. Replace the
Image
Processor
Board
(
page 8-87).
4 1. Replace the memory card
(page 8-91).
2.Does the error still occur?
Replace the
Image
Processor Board
(
page 8-87).
Complete.