Xerox Phaser 6280 - NVRAM Error

3-148 Phaser 6280 Color Laser Printer Service Manual
Error Messages and Codes
NVRAM Error
When the printer is turned On, the error is detected between the NVRAM size
required by the system and its actual size.
Applicable Chain Link
■ Chain Link 116-390: ESS NVRAM1 Size and ID Check Fail
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Image Processor Board, PL9.1.27
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1. Check the Image Processor Board
for correct installation.
2.Is the Image Processor Board
correctly installed?
Go to step 2. Reseat the
Image
Processor
Board
(
page 8-87).
2 Does the error still occur? Replace the
Image
Processor Board
(
page 8-87).
Complete.