ABB 615 Series - Section 6 Tolerances; 6.1 DNP 3.0 timing considerations

Frequency measurement f...............................................................918
Identification............................................................................... 918
Function block............................................................................ 918
Functionality............................................................................... 919
Signals........................................................................................919
Settings.......................................................................................919
Monitored data............................................................................920
Technical data............................................................................ 920
Technical revision history........................................................... 920
Sequence current measurement I1, I2, I0....................................... 920
Identification............................................................................... 920
Function block............................................................................ 921
Signals........................................................................................921
Settings.......................................................................................921
Monitored data............................................................................922
Technical data............................................................................ 923
Technical revision history........................................................... 923
Sequence voltage measurement V1, V2, V0...................................924
Identification............................................................................... 924
Function block............................................................................ 924
Signals........................................................................................924
Settings.......................................................................................924
Monitored data............................................................................925
Technical data............................................................................ 926
Three-phase power and energy measurement P, E........................927
Identification............................................................................... 927
Function block............................................................................ 927
Signals........................................................................................927
Settings.......................................................................................928
Monitored data............................................................................928
Technical data............................................................................ 930
Technical revision history........................................................... 930
Single-phase power and energy measurement SP, SE.................. 930
Identification............................................................................... 930
Function block............................................................................ 931
Signals........................................................................................931
Settings.......................................................................................931
Monitored data............................................................................932
Technical data............................................................................ 937
Digital fault recorder DFR..................................................................... 937
Table of contents
615 series ANSI 27
Technical Manual