ABB 615 Series - Section 1 Introduction; 1.1 This manual; 1.2 Intended audience

Dual single-pole high-speed power outputs HSO1, HSO2 and
HSO3 in BIO0007.......................................................................110
Signal output contacts .................................................................... 111
Internal fault signal output IRF ...................................................111
Signal outputs SO1 and SO2 in power supply module...............112
Signal outputs SO1, SO2, SO3 and SO4 in BIO0005................ 113
Signal outputs SO1, SO2 and SO3 in BIO0006......................... 113
RTD/mA inputs..................................................................................... 114
Functionality.................................................................................... 114
Operation principle.......................................................................... 114
Selection of input signal type......................................................114
Selection of output value format................................................. 115
Input linear scaling......................................................................116
Measurement chain supervision.................................................116
Self-supervision.......................................................................... 117
Calibration.................................................................................. 117
Limit value supervision............................................................... 117
Deadband supervision................................................................118
RTD temperature vs. resistance.................................................120
RTD/mA input connection...........................................................120
RTD/mA card variants................................................................ 123
Signals.............................................................................................126
Settings............................................................................................127
Monitored data.................................................................................128
SMV function blocks............................................................................. 129
IEC 61850-9-2 LE sampled values sending SMVSENDER............ 129
Function block............................................................................ 129
Functionality............................................................................... 130
Settings.......................................................................................130
IEC 61850-9-2 LE sampled values receiving SMVRECEIVER....... 130
Function block............................................................................ 130
Functionality............................................................................... 130
Signals........................................................................................130
ULTVTR function block....................................................................131
Function block............................................................................ 131
Functionality............................................................................... 131
Operation principle..................................................................... 131
Signals........................................................................................132
Settings.......................................................................................132
Monitored data............................................................................133
Table of contents
615 series ANSI 3
Technical Manual