118
To load a keygroup insert effect in the Pad Mixer:
1. Use the Program field at the top of the screen to select the desired program. Alternatively, use the Track field at
the top of the screen to select the desired track—the program it uses will be selected automatically.
2. Press a pad to select its corresponding keygroup, or tap it on the screen. Alternatively, use the Keygroup field
below the Program field.
Important: Remember that the effect will be applied to that keygroup only.
3. Tap the area under Inserts, and then use the screen that appears to load or edit effects. Alternatively, double-tap
the desired pad on the screen. You could also select one of the four Insert tabs at the bottom of the screen, and
then use the data dial or –/+ buttons to select an effect immediately.
To load a keygroup insert effect in Program Edit Mode:
1. While using the desired program, press the desired pad to select its keygroup. Alternatively, use the Keygroup
field at the top of the screen.
2. Tap the Effects tab in the lower-right corner, and use it to load or edit effects.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
