To Next Page

To Previous Page

323

Pad Parameter

In the Pad Parameter Q-Link Edit Mode, the Q-Link knobs control the same pad parameter for the each of the 16

pads in the current pad bank.

For example, if the Parameter is set to Level, the 16 Q-Link knobs will adjust the 16 independent Level settings for

each pad in the current pad bank. You could then set the Parameter to Pan and use the Q-Link knobs to adjust the

panning of all 16 pads.

Next to the top row of Q-Link knobs on the screen, tap one of these tabs to select the type of parameter you want to

control with the Q-Link knobs:

Mixer: general mixer parameters

Program: pad parameters (i.e., parameters used in Program Edit Mode)

Use the Parameter field to select the parameter you want to control with the Q-Link knobs.

Mixer: Off, Level, Pan, Pad Mute, Pad Solo, Send 1–4

Program:

Off Filter Env Attack Curve Layer Semi Tune (1–4) Layer Reverse (1–4)

Tuning Filter Env Decay Curve Layer Fine Tune (1–4) Layer Offset (1–4)

Filter Cutoff Filter Env Release Curve Velocity to Start Layer Loop Xfade (1–4)

Filter Resonance Pitch Env Attack Vel to Filter Attack Layer Loop Xfade Type (1–4)

Filter Env Amount Pitch Env Hold Velocity to Env Amount Layer Slice Tail Length (1–4)

Amp Env Attack Pitch Env Decay Velocity to Filter Layer Slice Tail Start (1–4)

Amp Env Decay Pitch Env Sustain LFO to Pitch Layer Pitch Random (1–4)

Amp Env Release Pitch Env Release LFO to Filter Layer Level Random (1–4)

Amp Env Hold Pitch Env Decay Mode LFO to Amp Layer Pan Random (1–4)

Amp Env Sustain Pitch Env Attack Curve LFO to Pan Layer Offset Random (1–4)

Filter Env Attack Pitch Env Decay Curve LFO Wave Attack Random

Filter Env Hold Pitch Env Release Curve LFO Rate Decay Random

Filter Env Decay Pitch Env Depth LFO Sync Cutoff Random

Filter Env Sustain Pitch Env Type Velocity to Pitch Resonance Random

Filter Env Release DrumFX (1–8) Vel to Volume Attack Total Random Amount

Amp Env Attack Curve DrumFX Type (1–8) Velocity to Amp LFO Level

Amp Env Decay Curve Layer Level (1–4) Velocity to Pan LFO Delay

mp En

Release Cu

ve Layer Sample Pan (1–4) Layer Slice (1–4) LFO Fade In

Tap the Momentary checkbox to turn momentary behavior on or off.

When on, moving the Q-Link knob will adjust its parameter, but the parameter will immediately return to its

original position (when you turned Momentary on) when you release the Q-Link knob.

When off, moving the Q-Link knob will adjust its parameter, and the parameter will remain at its new setting

when you release the Q-Link knob.

Akai MPC Live User Manual

Other manuals for Akai MPC Live