90
CV Programs
A CV program lets you send your control voltage (CV) signals
to an external MIDI device like a synth or drum machine that
uses CV.
To create a CV program:
1. Press Main to enter Main Mode.
2. Next to the Track field, tap the CV icon, which
indicates a CV program.
3. If the project does not contain a CV program yet, a
new CV program (named CV, appended with a
number) will be added automatically to the project and
appear in the Program field below.
If the project already contains a CV program, it will be
selected automatically and appear in the Program field
below.
To create another CV program, tap the + icon above
the Program field. A new CV program will be created
and appended with a number (e.g., CV 002).
4. Tap the keys icon to select a Melodic operation. This
is the same as the traditional CV program operation.
There are five additional settings to configure for a
Melodic CV program: the note tracking (Note), the CV
Port, the Gate Port, the modulation wheel (Mod
Wheel), and Velocity Port.
Tap the pads icon to select a Drum operation. In this
mode, tap the four squares with note icon to assign
each pad to a specific CV port and set its data type.
To rename the program, tap the cursor icon on the
right edge of the Program section. Use the virtual
keyboard that appears to enter a new name, and then
tap Do It to confirm or the gray bar at the top of the
screen to cancel.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
