482
WayOutWare Odyssey (continued)
Mod/Env
Use this tab to adjust the settings for the low frequency oscillator,
sample and hold generator, and envelope generator.
Parameter Description Value Range
LFO LFO Tempo
Sync
Determines whether LFO speed is free floating
or synced to project tempo.
Off, On
LFO Speed Speed of the low frequency oscillator.
When Sync is Off:
When Sync is On:
0.0925 – 20.0000 Hz
4/4 – 1/64 beats
Sample/Hold Trigger Determines the source signal for triggering the
Sample and Hold mixer, either the Low
Frequency Oscillator or the pitched Keyboard
output.
LFO Trigger, Kybd Trigger
Source 1 Selects the VCO-1 waveform or pulse width
modulation as Sample and Hold input.
Saw, Pulse
Source 2 Selects a noise generator or the VCO-2 pulse
width modulation as Sample and Hold input.
Noise, Pulse
CO-1 Level of the VCO-1 input. 0.0–100.0%
Depth Level of the noise or VCO-2 input. 0.0–100.0%
Lag Adjusts the smoothing of the Sample and Hold
output voltage.
0.0–100.0%
AR Attack Attack time of the AR envelope generator. 0.003 – 10.000 seconds
Release Release time of the
R envelope
enerator. 0.003 – 10.000 seconds
Trigger Source Determines the input source sent to the AR
envelope generator.
When set to KYBD Gate, the envelope
generator is triggered by key input.
When set to LFO Repeat, the envelope
enerator is tri
er by the LFO pulse wave.
KYBD Gate, LFO Repeat
ADSR Attack Attack time of the ADSR envelope generator. 0.003 – 10.000 seconds
Decay Decay time of the ADSR envelope
enerator. 0.003 – 10.000 seconds
Sustain Sustain time of the ADSR envelope generator. 0.000 – 10.000 V
Release Release time of the ADSR envelope
enerator. 0.003 – 10.000 seconds
Trigger Source Type of input to trigger the envelope generator. KYBD Gate, LFO Repeat
Repeat
When Trigger Source is set to LFO Repeat,
select KYBD Repeat for the LFO to trigger only
when a key is pressed, or select Auto Repeat
for the LFO to trigger automatically without key
input.
KYBD Repeat, Auto Repeat