139
Sequence Section
The Sequence section shows the current sequence and its information.
Use Sequence field to select a sequence.
To edit the name of the sequence, tap the cursor icon on the right edge of
the section, and use the virtual keyboard that appears.
Use the BPM field to adjust the tempo of the sequence.
To set whether the sequence follows its own tempo (Sequence) or a
global tempo (Global), tap the Sequence/Global button under the BPM field.
Alternatively, press and hold Shift+Tap.
Use the Bars field to adjust the length of the sequence in bars.
The Loop button shows whether the sequence (or a part of it) will loop or not.
To enable or disable looping, tap the button.
To set the start point and end point of loop, tap the Start or End field
(respectively) and then use the data dial or the –/+ buttons, or double-tap the
field and use the numeric keyboard that appears.
Note: The Last Bar value of the Delete Bars and Copy Bars processes
depends on the total length of the sequence.
Use the Transpose field to set the transposition (in semitones) of the entire
sequence.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
