412
AIR Instrument Plugins
MPC now includes three new plugin instruments: AIR TubeSynth, AIR Bassline, and AIR Electric.
AIR Bassline
The AIR Bassline plugin emulates the sound of classic
mono synths, with a contemporary twist. Bassline also
comes packaged with four integrated AIR effects (Chorus,
Delay, Compressor and Hype), as well as two built-in
distortion algorithms (Overdrive and Clip).
Osc/Filter/Envelope
Use this tab to adjust the settings for the oscillators,
as well as their filter and envelope settings.
Parameter Description Value Range
Oscillator Waveform Continuously variable waveshape for the oscillator. Saw Octave, Saw,
Square, Sine
Sub-Octave Amount of sub-octave oscillator. 0–100%
Fifth
mount of fifth-oscillator. 0–100%
Start Phase Position of the waveform when a note is triggered. Free, 0 degr., 180
de
r.
Glide Time Amount of time to slide from the pitch of one note to the next
note played.
10.0 ms – 2.00 s
Boost Boosts the si
nal of the oscillator. 0.0 – 48.0 dB
Boost Freq. Center frequency of the boost. * 1.0 – * 240.0
Boost
Envelope
Amount of effect of the envelope on the Boost section.
Adjust Gain to control the amount of boost.
Adjust Frequency to control the center frequency of the boost.
Gain 0–100%, Off,
Frequency 0–100%
Filte
LP Cutoff Cutoff frequency for the low-pass filter. 20.0 Hz – 20.0 kHz
Reso Resonance of the filter. 0–100%
Filter Env Envelope of the filter.
At negative values, decreases the cutoff value based on the
decay value.
At positive values, increases the cutoff value based on the
decay value.
-100% – 0 – +100%
HP Cutoff Cutoff frequency for the hi
h-pass filter. 10.0 – 500 Hz
Envelope Amp Attack Length of time for the note to reach full volume. 0–100 Soft,
0–100% Hard
Amp Decay Length of time for the note to reach the sustained volume. 0–100%
Filter Decay Len
th of time for the filter to reset after bein
released. 0–100%
Pitch Mod Amount of pitch modulation applied to the envelope. 0–100%
To Next Page
Loading...
Need help?
General
Weight and Dimensions
