121
To load XYFX for a program in XYFX Mode:
1. Select the desired program in another mode, and then enter XYFX Mode.
2. If you have not yet used XYFX Mode for this program, tap Insert XYFX on the screen to load it and show the XY
pad.
Note: If you already have four insert effects loaded, you will need to clear one of the insert effect slots before
doing this.
If you have already used XYFX Mode for this program, the XY pad will appear.
3. Tap XYFX Location in the upper-left corner, and select Program.
4. If the Setup panel is not shown, tap Setup in the lower-right corner to show it.
5. Use the Preset field to load an effect. Use the controls below the Preset field to edit the effect.
To load a program insert effect in the Channel Mixer:
1. Use the Mixer field in the upper-left corner to select Programs.
2. In the touchscreen, tap the pad that corresponds to the desired program. Alternatively, double-tap the Program
field below the Mixer field and tap the desired program.
3. Tap the area under Inserts, and then use the screen that appears to load or edit effects. Alternatively, tap the Insert
tab at the bottom of the screen (tap it multiple times to select a different insert slot), and then double-tap the desired
pad on the screen. You could also use the data dial or –/+ buttons to select an effect immediately.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
