To Next Page

To Previous Page

316

Tap the Learn button to turn Learn Mode on or off. When on, adjusting a control from your MPC touchscreen (in

standalone mode or controller mode) or MPC software (in controller mode) will immediately assign it to the currently

selected Q-Link knob.

This button is not available while in Screen Q-Link Edit Mode where the Q-Link knobs are unassignable.

To assign a function to a Q-Link knob in Learn Mode:

1. Tap Learn so the button is lit. (This will stop playback. Resuming playback will exit Learn Mode.)

2. Touch or turn the desired Q-Link knob.

3. In standalone mode, use the touchscreen to navigate to a slider, knob, or other control that you want to assign

to the Q-Link knob, and then adjust it. Or, in controller mode, adjust a control in the MPC software or from your

connected MPC hardware. The Q-Link knob will be able to control that parameter immediately.

To assign functions to other Q-Link knobs, repeat Steps 2–3.

To exit Learn Mode, tap Learn (or resume playback).

The automation button indicates the global automation state. This is shown in several modes. See General Features

> Automation to learn about this.

At any time, in any mode, you can show the Q-Links window over the touchscreen’s current contents. These are the

same parameters and settings as what is shown in Q-Link Edit Mode.

To show the Q-Links window, press and hold any of the Q-Link buttons: Project, Program, Pad Scene, Pad

Param, or Screen Control/Edit (MPC X) or the Q-Link button (MPC Live, MPC Live II, MPC One, MPC Key 61,

MPC Key 37, MPC Touch).

To close the Q-Links window, release that Q-Link button.

While the Q-Links window is shown:

To adjust the settings of the selected knobs, turn the corresponding Q-Link knobs on your MPC hardware.

To select an edit mode for the Q-Link knobs, tap one of the five buttons at the bottom of the screen. If you are

using MPC X, you can also press one of the five Q-Link buttons above the Q-Link knobs: Project, Program, Pad

Scene, Pad Parameter, or Screen.

To turn Learn Mode on or off, tap Learn. (This button is not available while in Screen Q-Link Edit Mode where

the Q-Link knobs are unassignable.)

To enter Q-Link Edit Mode immediately (regardless of the current mode), tap Q-Link Edit at the bottom of the

window.

To enable or disable the Q-Link overlay, tap Show Q-Link Status When Touched at the bottom of the

window. A panel will appear on the right side of the touchscreen showing the available parameters being

controlled and their values.

Akai MPC Live User Manual

Other manuals for Akai MPC Live