425
Reverb / Compressor / Hype
Use this tab to apply and adjust the settings for the built-in Reverb, Compressor and Hype effects.
Parameter Description Value Range
Reverb Mode Type of reverb applied. Hall, Stadium, Room,
bstract
Time Len
th of reverb tail. 0.4 s – +Inf s
Lo Cut Center frequency for the reverb low-pass filter. 1 – 1000 Hz
Hi Cut Center frequency for the reverb hi
h-pass filter. 1.0 – 20.0 kHz
Mix Wet/dry mix of the reverb effect. 0–100%
Compressor Threshold Signal level after which the compressor will be
applied.
0.0 – -60. dB
Output Amount of additional output gain for the compressed
si
nal.
0.0 – +30.0 dB
Mix Wet/dry mix of the compressor effect. 0–100%
Ratio
mount of compression applied. 1.0:1 – 100.0:1
Knee How gradually the compressor reacts as the threshold
is reached.
Lower values apply a "soft" knee (compression is
applied more slowly as signal approaches the
threshold), and higher values apply a "hard" knee
(compression is immediately applied when the
threshold is reached).
0–100%
ttack Len
th of time to apply the compression. 100 us – 300 ms
Release Length of time for compressed signal to return to
ori
inal level.
10 ms – 4.00 s
Hype Hi
h Dampens or maximizes hi
h end frequencies. -100 – 0 – +100%
Low Dampens or maximizes low end frequencies. -100 – 0 – +100%
To Next Page
Loading...
Need help?
General
Weight and Dimensions
