Akai MPC Live - Page 430

430
AIR Kill EQ
This effect can zap out the Low, Mid or High broadband
frequency from an audio signal.
Parameter Value Range Default Value
Hi
g
h Thru, Kill Thru
Mid Thru, Kill Thru
Low Thru, Kill Thru
Output -20.0 – +20.0 dB 0.0 dB
Hi
g
h Gain -Inf – +12.0 dB 0.0 dB
Mid Gain -Inf – +12.0 dB 0.0 dB
Low Gain -Inf – +12.0 dB 0.0 dB
Hi
g
h Freq. 500 Hz – 8.00 kHz 2.00 kHz
Offset -100 – +100% 0%
Low Freq. 50.0 – 800 Hz 200 Hz
AIR Lo-Fi
This effect is used to bit-crush, down-sample, clip, rectify and mangle an audio signal.
Tab Parameter
V
alue Range Default Value
Lo-Fi Bit Depth 1.0 – 16.0 bit 16.0 bit
Sample Rate 500 Hz – 50.0 kHz 50.0 kHz
Mix 0–100% 100%
Distortion Clip 0.0 – 40.0 dB 0.0 dB
Rectify 0–100% 0%
Noise Mod 0–100% 0%
A
nti-
A
lias Pre 0.125 – 2.000 Fs 0.5000 Fs
Post 0.125 – 2.000 Fs 1.000 Fs
Enable On, Off Off
LFO / Env Wave Sine, Tri, Saw, Square, Morse,
S&H, Random
Sine
Rate
Sync Off:
Sync On:
0.01 – 10.0 Hz
8/4 – 16
1.00 Hz
2T
Sync On, Off Off
Depth -100 – 0 – 100% 0%
A
ttack 0.1 – 10.0 s 0.5 s
Release 0.1 – 10.0 s 0.5 s
Depth -100 – 0 – 100% 0%