Akai MPC Live - Page 436

436
AIR Filter
This effect applies a filter to the audio
signal and then applies selectable
saturation or reduction to the filtered
signal.
Parameter Value Range Default Value
Cutoff Freq 55.0 Hz – 20.0 kHz 20.0 kHz
Reso Factor 0.7 – 20.0 1.0
Type LP4–1, BP2, BP4, HP2_LP1,
HP3_LP1, HP4–1, BR2, BR4,
BR2_LP1, BR2_LP2, HP1_BR2,
BP2_BR2, HP1_LP2, HP1_LP3,
A
P3,
A
P3_LP1, HP1_AP3
LP4
Output Gain -Inf dB – 0.0 dB 0.0 dB
Saturation
Type
Resample, Bit Crush, Rectify, Hard
Clip, Distort, Overdrive
Overdrive
Saturation
Drive
0.0 – 12.0 dB 0.0 dB
Saturation
Mode
DCF, CVF DCF
AIR Maximizer
This effect is a limiter optimized for professional
mastering.
Parameter Value Range Default Value
Th
r
eshold -40.0 – 0.0 dB -20.0 dB
Ceilin
g
-20.0 – 0.0 dB FS -5.0 dB FS
Look Ahead 0.0 – 20.0 ms 0.0 ms
Knee Hard, Soft Hard
Release 10.0 ms – 10.0 s 316 ms
LF Mono 10.0 Hz – 1.00 kHz 10.0 Hz
AIR Noise Gate
This effect is similar to a compressor, but instead of
attenuating audio signal that rises above a threshold, a
noise gate attenuates audio signal that falls below a
threshold by a set amount. This can help reduce
background noise in your audio signal.
Parameter Value Range Default Value
Threshold -120.0 – 0.0 dB -48.0 dB
Depth 0 dB – -120.0 dB -120 dB
Denoise Filter Off, On Off
Denoise Th
r
esh -120.0 – 0.0 dB -60.0 dB
A
ttack 0.01 – 1000.00 ms 0.18 ms
Hold 0 – 1000 ms 250 ms
Release 1.00 – 3000.00 ms 7.40 ms