475
AIR Mellotron (continued)
Delay / Spring Reverb
Use this tab to adjust the settings for the delay and spring reverb
effects. Each effect can be turned on and off by using the buttons
on the right side.
Parameter Description Value Range
Delay Use the button in the upper-right corner to enable or
disable delay.
Off, On
Time Amount of time between the dry signal and the
delayed si
nal.
1/16 – 16/4
L/R Ratio
Reduces the delay Time in either the Left or Right
stereo field. This is useful for creating offset, panned
delays.
50:100 – 100:100 –
100:50
Feedback Amount of signal fed back into the delay line. 0–100%
Mix Wet/dry amount of the delay effect. 0–100%
Reso LP Freq Low pass frequency for feedback resonance. 100 – 16000 Hz
Reso Bell Freq Center frequency for feedback resonance. 100 – 16000 Hz
Reso Bell Gain
mount of
ain applied to the resonant frequency. 0–100%
Spring Reverb Use the button in the upper-right corner to enable or
disable the sprin
reverb effect.
Off, On
Pre-Delay Length of time between dry signal and reverberated
si
nal.
0 – 250 ms
Time Len
th of reverb tail. 1.00 – 10.00 s
Low Cut Center frequency for reverb si
nal low-cut filter. 20 – 1000 Hz
Diffusion Rate of increasing density of reverb reflections.
At lower settings, the sound of individual reflections is
more present.
At higher settings, reflections are more uniform.
0–100%
Width Stereo width of reverb signal. Higher values give wider
stereo separation.
0–100%
Mix Wet/dry amount of the reverb effect. 0–100%
To Next Page
Loading...
Need help?
General
Weight and Dimensions
