480
AIR Solina (continued)
Delay / Spring Reverb
Use this tab to adjust the settings for the delay and spring reverb
effects. Use the buttons on the right side to enable or disable each
effect.
Parameter Description Value Range
Delay Time Amount of time between the dry signal and the delayed
signal.
1/16 – 16/4
L/R Ratio
Reduces the delay Time in either the Left or Right stereo
field. This is useful for creating offset, panned delays.
50:100 – 100:100 –
100:50
Feedback Amount of signal fed back into the delay line. 0–100%
LP Freq Low pass frequency for feedback resonance. 100 – 16000 Hz
Bell Freq Center frequency for feedback resonance. 100 – 16000 Hz
Bell Gain Amount of gain applied to the resonant frequency. 0–100%
Mix Wet/dry amount of the delay effect. 0–100%
Spring Reverb Pre-Delay Length of time between dry signal and reverberated
signal.
0 – 250 ms
Time Length of reverb tail. 1.00 – 10.00 s
Low Cut Center frequency for reverb signal low-cut filter. 20 – 1000 Hz
Diffusion Rate of increasing density of reverb reflections.
At lower settings, the sound of individual reflections is
more present.
At higher settings, reflections are more uniform.
0–100%
Width Stereo width of reverb signal. Higher values give wider
stereo separation.
0–100%
Mix Wet/dry amount of the reverb effect. 0–100%
To Next Page
Loading...
Need help?
General
Weight and Dimensions
