496
Use the controls on the left side of the Touch FX plugin window to adjust the settings for MPC Studio’s Touch Strip
control. For other hardware, you can control the Touch Strip by assigning it to a MIDI control or by using the virtual
touch strip on the touchscreen.
Touch Strip: This strip represents the MPC Studio’s touch strip control, and can also be controlled manually by
clicking and dragging from the software, tapping and dragging from a hardware touchscreen, or by assigning it a
MIDI control. Use this to control the selected Touch FX.
Touch Enable: Tap this box to enable touch control the currently selected Touch FX.
Assigned Parameter: Use this field to select a preset parameter to be controlled by the touch strip. This can be
separate from or in addition to controlling the Wet/Dry amount, depending on the Touch > Wet/Dry setting.
Touch Value: Use this slider to control the value of the Assigned Parameter controlled by the touch strip.
Wet Amount: Use this slider to set the blend the original signal (dry) and the effect signal (wet).
Touch Value / Wet/Dry Lock: Tap the lock icon to use the touch strip to control the Wet/Dry amount in
addition to the touch value of the Assigned Parameter.
Touch Attack: Use this slider to set the length of the attack phase of the envelope, which is triggered when you
move the touch strip control.
Touch Release: Use this slider to set length of the release phase of the envelope, which is triggered when you
release the touch strip control.
Use the controls on the right side of the Touch FX plugin window to select a Touch FX type and adjust its settings.
You can also select from the included presets at the top of the window.
Manual Filter
The touch strip controls a static, multi-mode filter without
modulation.
Parameter Value Range Default Value
Cutoff 40.00–10000 Hz 2530.00 Hz
Resonance 0.00–1.00 0.50
Mode LowPass,
BandPass, HiPass
LowPass
To Next Page
Loading...
Need help?
General
Weight and Dimensions
