Introduction CFC Media (SD Card)
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
1-90
Note: A USB slot is physically present on the faceplate, but there is no software support in 14.2. (USB
support will be available in a future release.)
The following SD flash memory cards are officially supported in the first release.
• SanDisk 2GB Flash card
• SanDisk 4GB SDHC Flash card
Note: Others brands can be used but are not guaranteed to work.
The SD cards are labeled as “SD4” (on the slot 4 CFC) and “SD5” (on the slot 5 CFC) and are managed via the
MEDIA commands. The SD cards (on both the active and inactive CFC) can be used in all commands that allow
media devices for either source or destination files, including:
BACKUP DATABASE
RESTORE DATABASE
BACKUP CONFIG
PUT LOG
COPY FILE
DELETE FILE
PUT FILE
RENAME FILE
SHOW FILE
Note: The RESTORE CONFIG is not supported from the SD card in 14.2 for either CFC.
Following are some sample input commands with the 2GB SD card.
show media
--- Media Devices ------------------------------------------------------
Unit State
-------------------------------------- ---------------------------------
SD4 UP Online
SD5 UP Online
-------------------------------------------------------------------------
show media sd5
-------------------------------------------------------------------------
Device Name SD5
Fault No Faults
Parent Card 5
Card Type SD MEDIA
State UP
Status Online
Serial Number 1894278981
Firmware Version 8.0
Number of Sectors 3862528
Bytes per Sector 512
Model SD02G
-------------------------------------------------------------------------
To Next Page
Loading...
