Introduction Configuring IGMP
Software Reference for SwitchBlade x3100 Series Switches (Internet Group Management
Protocol (IGMP))
5-14
ADD TRACE IGMPSNOOPING MESSAGETYPE
Syntax
ADD TRACE IGMPSNOOPING MESSAGETYPE={ REPORTV1 | REPORTV2 | LEAVE |
GENERALQUERY | LASTMEMBERQUERY | ALL } [ INTERFACE={ type:id-range
| id-range | ifname-list | ALL } ] [ MACADDRESS={ macaddress | ALL
} ] [ GROUPADDRESS={ ipaddress | ALL } ]
Description This command adds trace criteria. The parameters, when specified together in a single
command, are taken to be AND'ed together. Multiple invocations of this command are
OR'ed. If parameters are not specified, ALL is assumed.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example ADD TRACE IGMPSNOOPING MESSAGETYPE=LEAVE INTERFACE=1.23
Option Description Default Value
MESSAGE-
TYPE
The interface from which the MAC address was learned ALL
INTERFACE ALL
MACAD-
DRESS
The MAC address as learned from the source address
field of a frame, or entered as part of a static filter entry.
Example: 00:0C:25:00:13:8C
ALL
GROUPAD-
DRESS
The IP address of the multicast group
ALL - All IP addresses of the multicast groups
ALL
To Next Page
Loading...
Need help?
General
