Configuring IGMP Introduction
5-19
Software Reference for SwitchBlade x3100 Series Switches (Internet Group Management Pro-
tocol (IGMP))
ENABLE IGMPSNOOPING
Syntax
ENABLE IGMPSNOOPING [ INTERFACE={ type:id-range | id-range |
ifname-list | ALL } ]
Description The ENABLE IGMPSNOOPING command is used to enable the snooping for the inter-
cept and monitoring of the IGMP protocol messages that setup the layer 2 multicast
group information in the forwarding database.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
ENABLE IGMPSNOOPING INTERFACE=1.23
Option Description Default Value
INTERFACE
ALL Enable all interfaces