Configuring ACL Introduction
6-43
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
wards with the ADD ACCESSLIST command. ACCESSLIST RULEs are implemented
using CLASSIFIERS. The CLASSIFIERS used to implement a specific rule can be seen using
the FULL option on the SHOW CLASSIFIERS commands.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
CREATE ACCESSLIST=stb_range RULE=PERMIT IPSOURCE=172.16.5.0
SOURCEMASK=255.255.255.240
Option Description Default Value
ACCESSLIST The ACCESSLIST Name that already exists.
RULE PERMIT - permit packets that match the rule
DENY - drop packets that match the rule
DENY
match rule Refer to Ta ble 6- 7.
INTERFACE The interfaces that are to associated with the ACCESS-
LIST.
To Next Page
Loading...
