Configuring ACL Introduction
6-47
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
RESET ACCESSLIST
Syntax
RESET ACCESSLIST=accesslistname RULE=rulenumber
[ { PERMIT | DENY } ]
Description Clears all of the fieldname/fieldvalue pairs from the RULE, resulting in a classifier that
always matches all packets. This command does not remove association of the ACCESS-
LIST or INTERFACE(s). Use DELETE ACCESSLIST for those types of changes.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
RESET ACCESSLIST=metro RULE=2 PERMIT
Option Description Default Value
ACCESSLIST The ACCESSLIST Name that already exists.
RULE The rule number that is being reset.
Action PERMIT
DENY
Whatever was
previously applied
To Next Page
Loading...
Need help?
General
